F10W Portal Axle Fitment Guide
f10wptech guidevrd

F10W Portal Axle Fitment Guide

November 17, 2026

F10W Axle Installation Guide: VS4-10 and VRD Chassis Compatibility

With the release of the new F10W Axle Sets, you may be wondering what additional parts are required to install these axles on your existing Vanquish VS4-10 or VRD RC crawler chassis.

To help make your upgrade as straightforward as possible, we've put together this F10W axle fitment guide, outlining the additional components needed for each chassis configuration, including portal and straight axle setups.

Below you'll find the required parts for installing F10W-P axles on VS4-10 portal, VS4-10 straight axle, and VRD portal or straight axle-based chassis.

VS4-10 PORTAL BASED CHASSIS – PARTS NEEDED TO COMPLETE FOR F10W-P AXLE FITMENT

Front Axle

  • IRC00549 PANHARD AND DRAG LINK SET
  • IRC00523 S8E TUNING ROD END SET (+5MM ROD END FOR USE WITH 80MM SHOCKS)

Rear Axle

  • IRC00523 S8E TUNING ROD END SET (+5MM ROD END FOR USE WITH 80MM SHOCKS)

VS4-10 STRAIGHT AXLE BASED CHASSIS – NEEDED TO COMPLETE FOR F10W-P AXLE FITMENT

Front Axle

  • IRC00549 PANHARD AND DRAG LINK SET
  • IRC00523 S8E TUNING ROD END SET (-5MM ROD END FOR USE WITH 90MM SHOCKS)

Rear Axle

  • IRC00523 S8E TUNING ROD END SET (-5MM ROD END FOR USE WITH 90MM SHOCKS)

VRD PORTAL/STRAIGHT AXLE BASED CHASSIS – NEEDED TO COMPLETE FOR F10W-P AXLE FITMENT

Front Axle

  • VPS10402 – VFD STUBBY KIT FOR VRD
  • IRC00523 S8E TUNING ROD END SET (+5MM ROD END TO MAINTAIN STOCK RIDE HEIGHT)
  • Builder's Links - 106MM FRONT LOWER LINKS

     

    Additional fitment notes:

    • Minor trimming may be required on the skid plate around the front lower link rod end to provide sufficient clearance.
    • Depending on the servo being used, M3x10mm washer head screws may be required to provide adequate crossmember clearance.

 Rear Axle

  • IRC00523 S8E TUNING ROD END SET (+5MM ROD END TO MAINTAIN STOCK RIDE HEIGHT)

Ready to Upgrade to F10W Axles?

Whether you're running a VS4-10 portal chassis, VS4-10 straight axle chassis, or a VRD-based build, this guide should help you identify the additional components needed to complete your F10W-P axle installation.

Make sure to check your existing chassis configuration, shock length, and component requirements before starting your upgrade.